Sony SLV-M10HF - Manual (Page 39)

Setting up cable
box control
(Skip this section if you are
using Hookup 2, 3, 4, or 6.)
-T
) ~
0 ca> OB Q
'O '© ©
'© © ©
©
CD
0 CD (i>
IS) S) CD
Your VCR includes a cable box control
feature that allows the VCR to control
most brands of cable boxes / DSS
receivers via the Cable Mouse. With
cable box control, the VCR controls
channels on the cable box / DSS receiver
for timer recording. You can also use the
VCR's remote commander to change
channels on the cable box/DSS receiver
whenever the cable box/DSS receiver is
turned on even if the VCR is turned off. To use cable box control, you
need to connect the Cable Mouse (pages 11 and 24) and set the code
number and output channel.
This VCR is programmed with codes necessary to control channel
selection on most brands of cable boxes at the time this VCR was
manufactured. It is possible that new cable boxes may be introduced
that cannot be controlled with this VCR's Cable Mouse. If you have a
cable box that is incompatible with this VCR, contact your cable
operator — they may be able to provide you with a compatible cable
box.
Number
buttons
CH +/-
MENU
Cursor stick
OK
PUSH OK
2
Press MENU, then push the cursor stick to
/ 4’ to move the cursor to CABLE BOX
CONTROL and press the cursor stick
(OK).
When using the EASY SET UP procedure,
skip this step.
CURSOR Push the cursor stick to •^/^ to select
ON, then push the cursor stick to 4
PUSH OK
ON lo^
Use 1 o select
Push iMENUl 1 0 quit
BOX OUTPUT CH
Enter your Cl^BIrE BOX
Code No. using |0-9] keys
Refer to the Operating
Manual for the Code
continued
Getting Started