Sony MDS-101 - Manual (Page 46)

Labeling Recordings (TITLE Function)
(Continued from previous page.)
4
Repeat step 3 until you have entered the
entire title.
lUE SONGS^ y ^ c i i i V “
Press NAME again.
The entered title appears from the leftside of the
display window and the disc labeling
procedure is
completed.
[ nam ^
DR I ME SOHGS
16 17 It
Entering iowercase ietters
1 Press CAPS until "Selected abc" lights up.
2 Enter the desired characters.
Entering uppercase ietters
1 Press CAPS until “Selected ABC" lights up.
2 Enter the desired characters.
Entering numbers
1 Press NUM until “Selected 123” lights up.
2 Enter the desired numbers.
Entering uppercase or lowercase letters again
1 Press CAPS or NUM until “Selected ABC" or
“Selected abc” lights up.
2 Enter the desired characters.
Entering symbols { » , ? , ¥ , etc.)
1 Press or ► ► on the remote commander to select the
desired character.
2 Press i
The following symbols can be used on your unit: I ” # $ % & ’
( ) * + , - . / : ; < = > ? @ [ ¥ ) ' ' _ - { 1 ) ~
However, the display of the ( ¥ J { |) ~ symbols may not be
supported on certain models of MD player units.
46
If you enter the wrong character
1 Press or to move the flashing cursor under the
character to be corrected.
@ 1^
2 Press CLEAR to erase the incorrect character, then enter
the correct letter.
To cancel the title function
Press ■ .
Making a correction after entering a title
1 Press NAME while the unit is stopped. The current disc
title lights up.
2 To enter an entirely new disc title, hold down CLEAR until
the current track title is erased, then enter the correct disc
title.
To correct a part of the disc title, use the same procedure
described in “If you make a mistake” above.
3 Press NAME.
I Notes I
if the "Protected” indication lights up
The record-protect slot on the disc is open and the disc cannot be labeled. Label
the disc after closing the slot.
W hen “TOC” flashes in the display window
Do not jog the unit or pull out the power cord. After the contents of the recording
have been updated, “TOC" lights up. If any changes have been m ade to an M D, the
“TOC" indicator lights up. W hen EJECT or POW ER is pressed at this tim e, the
"TOC" indicator flashes and the actual contents of the M D are updated.