10 press ■ to stop recording, To check the remaining time on the disc, To stop recording temporarily – Sony MDS-101 User Manual
Page 28: To eject a disc, Adjusting the recording level, Play the sound source to be recorded, To protect a minidisc against accidental erasure, Recording from the line (analog) input jack, 4 rec ready
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recording From the Line (Analog) Input Jack
(Continued from previous page.)
Restart the sound source to be recorded.
The track number being
recorded and elapsed
recording time (in minutes and seconds) appear.
00r
“II "goes off.
10
Press ■ to stop recording.
Recording stops.
To check the remaining time on the disc
See page 26.
To stop recording temporarily
Press Ml ( I I ) .
Press
► ll
(► or
II
) again to restart recording.
To eject a disc
Press EJECT
±.
Adjusting the recording level
When recording sound sources through the line (analog)
input jack or microphone, the recording level must be
adjusted to achieve the optimum recording level.
1 Press REC • {•) to put the unit into
recording pause.
Play the sound source to be recorded.
While monitoring the sound through the
headphones, adjust the recording level using
the REC LEVEL control.
Adjust the recording level so the peak level meter
reaches its highest point with the least intrusion
into the red (OVER) zone.
4 REC Ready
► II
/SS\
Press I ( ^ or 11 ) to start recording.
\
Notes
I
if “Protected'’ appears in the display window
The disc is write-protected. Close the slot to record on the disc (see “To protect a
M iniDisc against accidental erasure’ on this page).
W hen “TOC” flashes in the display window
Do not jog the unit or pull out the power cord.
W hen recording starts
PROGRAM or SHUFFLE play is canceled.
To protect a MiniDisc against accidental erasure
Record-protect tab
Open the slot to prevent recording.
Close the slot to allow recording.
28