Sony MDS-101 - Manual (Page 36)

Erasing Recordings (ERASE Function)
If your recorded M D has been divided into tracks, you can use the procedure
below to erase specific tracks easily and instantly. Note, however, that once
erased, a track cannot be recovered.
Erasing a single track
You can erase a track while the unit is in stop, playback or
pause m ode sim ply by specifying its respective track
num ber.
36
Press YES.
"Com plete” lights up for a few seconds then
disappears, and the specified track is erased.
The m usic calendar decreases by one.
— YES
O
Complete
•^5
6 7 a ft 10
11 13 13 14 IS
-m-t, -
W 17
W hen erasing a track during playback, the
following track begins playing after the erasure is
m ade.
To cancel the ERASE Function
Press . 43 . or to restore the norm a) display.
I Notes I
If the following indication goes on
4 Erase!!
The track has been recorded or edited on another unit and is write-protected. If this
indication appears, press YES to erase the track.
If the ’’Protected" indication lights up
The record-protect slot on the disc is open and the specified track cannot be
erased. Erase the track after closing the slot.
When "TOC” flashes in the display window
Do not jog the unit or pull out the power cord. After the contents of the recording
have been updated, “TOC" lights up. II any changes have been m ade to an M D. the
“TOC" indicator lights up. W hen EJECT or POW ER is pressed at this tim e, the
“TOC" indicator flashes and the actual contents of the M D are updated.