Sony MDS-101 - Manual (Page 15)

Setting the Clock
To stamp the time and date on recordings, set the built-in
clock. When playing back the recorded disc, the date and
time of the recording will appear in the display window.
Example: Setting the clock to 1993, April 23, 9:10 PM.
1-5 2-6
Keep pressing CLOCK SET for about 2
seconds until the year starts to flash.
CLOCK SET
o
01 n 01 di 935"
Enter the current year by pressing ffi °r I'T. ■
Pressing ^ increases the year and pressing
decreases the year. Holding down the respective
button increases or decreases the year faster.
After entering the year, press CLOCK SET.
The month flashes.
)li3- 01d 93y
Enter the month by pressing or .
After entering the month, press CLOCK SET.
The day flashes.
0 4 hl-î 0 1 d" 9 3 y
Enter the day by pressing tti .
After entering the day, press CLOCK SET.
04n 23d 93y
O
FRI-JflM 12^-00
The day of the week automatically appears and the
hour flashes.
Enter the hour by pressing or .
After entering the hour, press CLOCK SET.
The minutes flash.
FRI PM 09T0'0>
Enter the minutes by pressing K| or .
7
Press CLOCK SET in synchronization with the
time signal.
0411 23d 93y
O
FRI PM 09:10
The clock setting is displayed in order of date, then
time.
To display the current date and tim e
Press the CLOCK SET button on the front panel once to display the dale, then
again to display the tim e. W hen using the rem ote com m ander, press the DATE
PRESENT button. The date, then the tim e are displayed in sequence.
To change the display while the unit is off
Your unit can display either “STANDBY” or the current tim e when it is off (in standby
m ode). Choose one or the other by pressing the DISPLAY button.
For m ore precise tim e stam ping of recordings
It is recom m ended that you set the clock once a week.
15