Sony MDS-101 - Manual (Page 26)

Recording a Digital Source
To check the remaining time on the disc
Press DISPLAY.
If pressed while the unit is stopped, each press changes the
display as follows: total recorded time, remaining time on the
disc, disc name.
if pressed while the unit is in recording pause mode ("REC
Ready” lights up): the remaining time on the disc appears for
a few seconds, followed by the "REC Ready" indication.
If pressed while the unit is in recording mode: the remaining
time on the disc appears.
Press again to display the elapsed recording time.
To stop recording temporarily
Press
Ml (II).
Press ^41 (► or II) again to restart recording.
Whenever recording is restarted, the track number increases
by one. For example, if you stopped recording temporarily
while recording the 4th track, recording continues on the 5th
track when restarted.
To eject the disc
Press EJECT ±.
1 Notesl
if "Protected” appears in the display window
The disc is write-protected. Close the slot to record on the disc (see page 28).
M D recording and the Serial Copy M anagem ent System
Since your unit uses the SCMS (Serial Copy M anagem ent System ), M Os recorded
through the digital input jack cannot be used to m ake subsequent copies onto other
M Ds (see page 50).
W hen "TOC” flashes in the display window
Oo not jog the unit or pull out the power cord.
W hen recording starts
PROGRAM or SHUFFLE play is canceled.
W hen recording from a Sony portable M O player or other digital source
Press ■ on your M D unit to stop recording before stopping playback
on the other unit.
If you stop playback on the other unit - or disconnect the optical
cable - without stopping the recording first, the contents recorded to
that point will not be affected; however, playback on your M D unit
will be disabled after the recording is stopped.
If this should occur, reinsert the recorded M D into your MD unit to
reactivate the playback function.
Playing back tracks just recorded
Tracks that have just been recorded can be played back
immediately.
Playing back from the first track of the disc after you
have finished recording
1 Press ■ to stop recording.
2 Press ■ again.
3 Press
► 1I(^- or II).
Playback starts from the first track of the disc.
I
Notes
I
W hen recording from digital sound sources
Track num bers are autom atically recorded in the sam e sequence as the sound
source (i.e., based on changes in the em phasis data).
W hen dubbing another M iniOisc
Track num bers are autom atically recorded in the sam e sequence as the source
disc. However, if the sam e (rack is recorded repeatedly (i.e., when played back
repeatedly during program play or single-track repeat play), the sam e track num ber
is recorded each tim e.
26