Cisco XR 12410 - Manual (Page 181)

5-9
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Chapter 5 Maintaining the Router
Removing and Replacing the Blower Module
Removing and Replacing the Blower Module
Use the following procedure to remove and replace the blower module.
Step 1 Remove the blower module from the chassis ( Figure 5-5 ):
a. Loosen the captive screw on each side of the blower module.
b. Pull the blower module halfway out of the module bay.
c. Slide out the blower module completely from the module bay while
supporting it with your other hand.
Warning The blower module weighs approximately 20 pounds (9 kg). Use two hands
when handling the blower module.
Figure 5-5 Removing the Blower Module
52643
AC T
0
DO
WN LOOP
RA
LA
CDHNT
CD
TX 0 RX
TX 1
RX
DO
WN LOOP
RA
LA
CDHNT
CD
TX 0
RX
TX 1