Cisco XR 12410 - Manual (Page 75)

2-25
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Chapter 2 Preparing for Installation
PRP Port Connection Guidelines
PRP Console Port Signals
The PRP console port is a DCE RJ-45 interface for connecting a terminal to the
router. The console port does not support modem control or hardware flow control
and requires a straight-through RJ-45 cable.
Before connecting a terminal to the console port, check the terminal setting for
the data transmission rate, in bits per second (bps). The terminal transmission rate
setting must match the default rate of the PRP console port, which is 9600 bps.
Set the terminal to these operational values: 9600 bps, 8 data bits, no parity, 2 stop
bits (9600 8N2).
Table 2-3 lists the signals used on the console port.
Table 2-3 PRP Console Port Signals
Console Port Pin Signal Input/Output Description
1
1
1. These pins are not connected.
— — —
2 DTR Output Data terminal ready
3 TxD Output Transmit data
4 GND — Signal ground
5 GND — Signal ground
6 RxD Input Receive data
7 DSR Input Data set ready
8
1
— — —