Cisco XR 12410 - Manual (Page 41)

1-27
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Chapter 1 Product Overview
Line Card and Route Processor Overview
PRP SDRAM
The PRP uses Error Checking and Correction (ECC) Synchronized Dynamic
Random Access Memory (SDRAM) to store routing tables, protocols, network
accounting applications, and to run Cisco IOS software.
Table 1-5 lists the DRAM configurations for the PRP. If you are using:
• One DIMM—Bank 1 (U15) must be populated first.
• Two DIMMs—You cannot mix memory sizes; both banks must contain the
same size DIMM.
Caution DRAM DIMMs must be 3.3-volt, 60-nanosecond devices only. Do not attempt to
install other devices in the DIMM sockets. To prevent memory problems, use the
Cisco approved memory products listed in
Table 1-5 .
PRP-3 provides more system memory than PRP-2. PRP-3 is shipped with 2 GB
of system memory in each DDR2 DRAMs, for a total of 4 GB and provides an
upgrade option for a total of 8 GB (4 GB x 2 DRAM).
Note The two DIMMs must be of the same sizes. Do not use two different DIMM sizes
together.
Table 1-5 PRP-2 DRAM Configurations
Total
SDRAM
SDRAM Sockets Number of DIMMs
2 GB
1
1. Default shipping configuration.
U15 (bank 1)
U18 (bank 2)
One 2 GB DIMM
or
Two 2 GB DIMMs
4 GB U15 (bank 1)
U18 (bank 2)
One 4 GB DIMM
or
Two 4 GB DIMMs