Cisco XR 12410 - Manual (Page 77)

2-27
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Chapter 2 Preparing for Installation
PRP Port Connection Guidelines
Figure 2-13 shows:
• You cannot access Network 2.0.0.0 from Ethernet port (E0) on the PRP in
Router A. You can only access Host A, Host B, and Router C, which are in
Network 1.0.0.0 (see dotted-line arrows).
• To access Network 2.0.0.0 from Router A, you must use an interface port on
one of the line cards (a POS line card in this example) in Router A. Data from
Router A is routed through Router B and Router C, to reach Network 2.0.0.0
(see solid-line arrows).
Figure 2-13 Using the Ethernet Port on the PRP
Router A
(Cisco 12000
series router)
Router B
(Cisco 7500
series router) Router C
(Cisco 7500
series router)
POS
EO
Host A
Network 1.0.0.0
EO
Host B
26196
Host A
Network 2.0.0.0