Dell PowerEdge T410 - Manual (Page 93)

Installing System Components
93
Figure 3-6. Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1 Align the cooling shroud with the alignment guides in the system.
2 Hold the touch points on the cooling shroud and carefully lower the
cooling shroud into the system. Ensure that no cables are pinned under
the edges of the cooling shroud.
3 Hold the touch points and lower the expansion card stabilizer.
4 Close the system. See "Closing the System" on page 91.
5 Place the system upright and on its feet on a flat, stable surface.
6 Rotate the system feet outward.
7 Reattach any peripherals, then connect the system to the electrical outlet.
8 Turn on the system and attached peripherals.
1 expansion card stabilizer touch
points (2) 2 expansion card stabilizer
3 cooling shroud 4 cooling shroud touch points (2)
1 2
3
4
book.book Page 93 Tuesday, June 9, 2009 4:09 PM