Dell PowerEdge T410 - Manual (Page 85)

Installing System Components
85
Front Bezel
NOTE:
If you are removing or installing a hot-swappable hard drive, the system may
remain turned on and in the upright position during removal of the front bezel. If you
are removing or installing any other system component(s), the system should be
turned off and placed in the orientation shown in Figure 3-1.
Removing the Front Bezel
1 Using the system key, unlock the front bezel (if locked).
2 Slide the release latch in the direction of the arrow and rotate the top end
of the bezel away from the chassis.
3 Lift the bezel away from the chassis.
1 system cover 2 cooling shroud
3 PCIe expansion card slots (5) 4 system fan
5 power supply bay 6 heatsink and processor (1 or 2)
7 SAS backplane 8 system feet (4)
9 SAS or SATA hard drives (up to 6) 10 control panel
11 tape drive (optional) 12 optical drive (optional)
13 chassis intrusion switch 14 RAID battery (optional)
15 expansion card stabilizer
book.book Page 85 Tuesday, June 9, 2009 4:09 PM