Dell PowerEdge T410 - Manual (Page 40)

40
About Your System
E2113 Mem mirror OFF
on DIMM ## &
##. Power
cycle AC
The system BIOS has
disabled memory
mirroring because it has
determined one half of the
mirror has had too many
errors. "## & ##"
represents the memory-
module pair implicated by
the BIOS. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Troubleshooting
System Memory" on
page 162.
I1910 Intrusion
detected.
Check chassis
cover.
System cover has been
removed. Information only.
I1911 LCD Log Full.
Check SEL to
review all
Errors.
LCD overflow message. A
maximum of ten error
messages can display
sequentially on the LCD.
The eleventh message
instructs the user to check
the SEL for details on the
events. Check the SEL for details
on the events.
Remove AC power to the
system for 10 seconds or
clear the SEL.
I1912 SEL full.
Review & clear
log.
The SEL is full of events
and is unable to log any
more. Check the SEL for details
on the events, then clear
the SEL.
I1920 iDRAC6 Upgrade
Successful
iDRAC6 Express card has
been installed correctly Information only
W1228 RAID
Controller
battery
capacity <
24hr.
Warns predictively that
the RAID battery has less
than 24 hours of charge
left. Allow RAID battery to
charge to greater than 24
hours of sustained charge.
If problem persists,
replace RAID battery. See
"Installing a RAID
Battery."
Table 1-2. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 40 Tuesday, June 9, 2009 4:09 PM