Dell PowerEdge T410 - Manual (Page 28)

28
About Your System
LCD Status Messages (Optional)
The LCD messages refer to events recorded in the System Event Log (SEL).
For information on the SEL and configuring system management settings,
see the systems management software documentation.
NOTE:
If your system fails to boot, press the System ID button for at least five
seconds until an error code appears on the LCD. Record the code, then see "Getting
Help" on page 185.
Table 1-2. LCD Status Messages
Code Text Causes Corrective Actions
N/A SYSTEM NAME A 62-character string that
can be defined by the user
in the System Setup
program.
The SYSTEM NAME
displays under the
following conditions:
• The system is powered
on.
• The power is off and
active errors are
displayed.
This message is for
information only.
You can change the
system ID and name in
the System Setup
program. See "Entering
the System Setup
Program" on page 62.
E1000 Failsafe
voltage error.
Contact
support.
Check the system event
log for critical failure
events. Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 185.
E1114 Ambient Temp
exceeds
allowed range.
Ambient temperature has
a reached a point outside
of the allowed range. See "Troubleshooting
System Cooling
Problems" on page 161.
book.book Page 28 Tuesday, June 9, 2009 4:09 PM