beautypg.com

Jumpers and connectors, Jumpers—a general explanation, System board jumpers – Dell PowerEdge 1750 User Manual

Page 2: Jumpers

background image

Back to Contents Page

Jumpers and Connectors

Dell™ PowerEdge™ 1750 Systems Installation and Troubleshooting Guide

  

Jumpers—A General Explanation

  

System Board Jumpers

  

System Board Connectors

  

SCSI Backplane Board Connectors

  

Disabling a Forgotten Password


 

This section provides specific information about the jumpers on the system board. It also provides some basic information on jumpers and switches and

describes the connectors and sockets on the various boards in the system.

Jumpers—A General Explanation

 

Jumpers provide a convenient and reversible way of reconfiguring the circuitry on a printed circuit board. When reconfiguring the system, you may need to

change jumper settings on the system board. You may also need to change jumper settings on expansion cards or drives.

Jumpers

 

Jumpers are small blocks on a circuit board with two or more pins emerging from them. Plastic plugs containing a wire fit down over the pins. The wire

connects the pins and creates a circuit. To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated.

Figure A

-1

shows an example of a jumper.

Figure A-1. Example Jumper

 

 

 

A jumper is referred to as open or unjumpered when the plug is pushed down over only one pin or if there is no plug at all. When the plug is pushed down

over two pins, the jumper is referred to as jumpered. The jumper setting is often shown in text as two numbers, such as 1-2. The number 1 is printed on the
circuit board so that you can identify each pin number based on the location of pin 1.

System Board Jumpers

 

Figure A

-2

shows the location and default settings of the jumper blocks on the system board. See

Table A

-1

for the designations, default settings, and

functions of the system's jumpers.

Figure A-2. System Board Jumpers

 

 

CAUTION:

Make sure the system is turned off before you change a jumper setting. Otherwise, damage to the system or unpredictable results may

occur.