Dell Precision 370 User Manual
Page 98
A possible floppy or
hard drive failure has
occurred.
Reseat all power and data cables and restart the computer.
A possible USB failure
has occurred.
Reinstall all USB devices, check cable connections, and then restart the
computer.
No memory modules
are detected.
If you have one memory module installed,
and restart the
computer.
If you have two or more memory modules installed, remove the modules,
, and then restart the computer. If the computer
starts normally, reinstall an additional module. Continue until you have
identified a faulty module or reinstalled all modules without error.
If available, install properly working memory of the same type into your
.
System board failure
has occurred.
Memory modules are
detected, but a
memory configuration
or compatibility error
exists.
Ensure that no
/memory connector placement
requirements exist.
that you are installing are compatible
with your computer.
Reinstall the memory modules and restart the computer.
.
A possible system
board resource and/or
hardware failure has
occurred.
Perform the procedures in "
Resolving Software and Hardware Incompatibilities
.
A possible expansion
card failure has
occurred.
1. Determine if a conflict exists by
and restarting the computer.
2. If the problem persists, reinstall the card that you removed, remove a
different card, and then restart the computer.
3. Repeat this process for each card. If the computer starts normally,
troubleshoot the last card removed from the computer for resource
conflicts (see "
Resolving Software and Hardware Incompatibilities
.
Another failure has
occurred.
Ensure that the cables are properly connected to the system board from
the hard drive, CD drive, and DVD drive.
.
The computer is in a
normal operating
condition after POST.
None.