Dell diagnostics, When to use the dell diagnostics, Starting the dell diagnostics from your hard drive – Dell Precision 370 User Manual
Page 103

battery. See "Replacing the Battery."
Timer chip counter 2 failed —
Run the
Unexpected interrupt in protected mode —
.
WARNING: Dell's Disk Monitoring System has detected that drive [0/1] on the [primary/secondary]
IDE controller is operating outside of normal specifications. It is advisable to immediately back up
your data and replace your hard drive by calling your support desk or Dell —
If no replacement drive is immediately available and the drive is not the only bootable drive,
and change the appropriate drive setting to None. Then remove the drive from the computer.
Write fault —
Write fault on selected drive —
See "
."
The floppy drive cannot read the disk.
Insert a floppy disk into the drive and try again.
Dell Diagnostics
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
When to Use the Dell Diagnostics
If you experience a problem with your computer, perform the checks in "
" and run the Dell Diagnostics
before you contact Dell for technical assistance.
It is recommended that you print these procedures before you begin.
NOTICE:
The Dell Diagnostics works only on Dell™ computers.
, review your computer's configuration information, and ensure that the device you want to test displays in
system setup and is active.
Start the Dell Diagnostics from either your
Drivers and Utilities CD (also known as the ResourceCD).
Starting the Dell Diagnostics From Your Hard Drive
1. Turn on (or restart) your computer.
2. When the DELL™ logo appears, press
NOTE:
If you see a message stating that no diagnostics utility partition has been found, run the
your Drivers and Utilities CD.
If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft® Windows®
desktop. Then
3. When the boot device list appears, highlight Boot to Utility Partition and press
4. When the Dell Diagnostics Main Menu