Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 41)

When performing the following procedures, reference the appropriate figures according to the type of NAS systems that are
installed in your cluster.
1. Locate two SCSI cables containing a 68-pin connector (for the PowerVault storage systems) and an ultra high density
connector interface (UHDCI) connector (for the PERC controllers).
2. Ensure that the SCSI cables are long enough to connect your PowerVault storage systems to your PowerVault NAS
systems.
3. Locate connectors A and B on the back panel of your PowerVault storage system.
Figure 3-1 shows the back panel of the PowerVault 21xS storage system, and Figure 3-1 shows the back panel of the
PowerVault 22xS storage system.
Figure 3-1. PowerVault 21xS Back Panel
Figure 3-2. PowerVault 22xS Back Panel
4. On the first SCSI cable, connect the 68-pin connector to SCSI connector A on the back of your PowerVault storage
system.
5. Tighten the retaining screws on the SCSI connector.
6. On the second SCSI cable, connect the 68-pin connector to SCSI connector B on the back of your PowerVault storage
system.
7. Tighten the retaining screws on the SCSI connector.