Removing a hard-drive blank – Dell DX6000 User Manual
Page 85
Installing System Components
85
CAUTION:
Before attempting to remove or install a drive while the system is
running, see the documentation for the storage controller card to ensure that the
host adapter is configured correctly to support hot-swap drive removal and
insertion.
CAUTION:
Do not turn off or reboot your system while the drive is being formatted.
Doing so can cause a drive failure.
NOTE:
Use only drives that have been tested and approved for use with the SAS
backplane board.
When you format a hard drive, allow enough time for the formatting to be
completed. Be aware that high-capacity hard drives can take a number of
hours to format.
Removing a Hard-Drive Blank
CAUTION:
To maintain proper system cooling, all empty hard-drive bays must
have drive blanks installed.
1 Remove the front bezel. See "Removing the Front Bezel" on page 81.
2 Grasp the front of the hard-drive blank, press the release lever on the
right side, and slide the blank out until it is free of the drive bay. See
Figure 3-4. Removing and Installing a Hard Drive Blank
1
3.5-inch hard drive blank
2
release latch
1
2