Dell DX6000 - Manual (Page 32)

32 About Your System
E1810 Hard drive ##
fault. Review
& clear SEL.
The specified hard drive
has experienced a fault.
See "Troubleshooting a
Hard Drive" on page 168.
E1812 Hard drive ##
removed.
Check drive.
The specified hard drive
has been removed from the
system.
Information only.
E1A11 PCI Riser
hardware &
configuration
mismatch.
Reconfigure.
PCIe risers are not
configured correctly. Some
invalid configurations
prevent the system from
powering on.
Reinstall the expansion-
card riser. See "Expansion
Cards and Expansion-
Card Risers" on page 120.
If the problem persists,
the riser card or system
board is faulty. See
"Getting Help" on
page 189.
E1A12 PCI Riser not
detected.
Check Riser.
One or both of the PCIe
risers are missing. This
prevents the system from
powering on.
Reinstall the missing riser
card(s). See "Replacing
Expansion-Card Riser 1"
on page 125 and
"Replacing Expansion-
Card Riser 2" on page 127.
E1A14 SAS cable A
failure.
Check
connection.
SAS cable A is missing or
bad.
Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help" on
page 189.
E1A15 SAS cable B
failure.
Check
connection.
SAS cable B is missing or
bad.
Reseat the cable. If the
problem persists, replace
cable.
If the problem persists,
see "Getting Help" on
page 189.
Table 1-1. LCD Status Messages (continued)
Code Text Cause Corrective Actions