beautypg.com

Dell DX6000 User Manual

Page 54

background image

54

About Your System

Warning! Power

required exceeds

PSU wattage.

Check PSU and

system

configuration.

Warning!

Performance

degraded. CPU and

memory set to

minimum

frequencies to

meet PSU wattage.

System will

reboot.

The system configuration of

processor(s), memory

modules, and expansion

cards may not be supported

by the power supplies.

If any system components

were just upgraded, return

the system to the previous

configuration. If the system

boots without this warning,

then the replaced

component(s) are not

supported with this power

supply. If Energy Smart

power supplies are installed,

replace them with High

Output power supplies to use

the components. See "Power

Supplies" on page 90.

Warning! PSU

mismatch. PSU

redundancy lost.

Check PSU.

A High Output power supply

and an Energy Smart power

supply are installed in the

system at the same time.

Install two High Output or

two Energy Smart power

supplies in the system.
You can also run the system

on one power supply until

you can obtain two power

supplies of the same type.

See "Troubleshooting Power

Supplies" on page 161.

Warning!

Unsupported

memory

configuration

detected. The

memory

configuration is

not optimal. The

recommended

memory

configuration

is: .

Invalid memory

configuration. The system

will run but with reduced

functionality.

Ensure that the memory

modules are installed in a

valid configuration. See

"General Memory Module

Installation Guidelines" on

page 131. If the problem

persists, see

"Troubleshooting System

Memory" on page 163.

Table 1-2. System Messages

(continued)

Message

Causes

Corrective Actions