Dell PowerVault MD3000i - Manual (Page 143)

Script Commands
143
Diagnose RAID Controller Module
This command runs diagnostic tests on the RAID controller module.
The testID parameter takes the following options, which you can use to verify
that a RAID controller module is functioning correctly:
• 1 — Reads the test
• 2 — Performs a data loop-back test
• 3 — Writes the test
The diagnostic tests consist of loop-back tests in which data is written to
physical disks and read from the physical disks.
Syntax
diagnose controller [(0 | 1)]
loopbackPhysicalDiskChannel=(allchannels | (1 | 2
)) testID=(1 | 2 | 3 | discreteLines)
[patternFile=" filename "]
virtualDisk or virtualDisks Name of the virtual disk to delete. You
can enter more than one virtual disk
name. You must put brackets ([ ]) around
the virtual disk name. If the virtual disk
name has special characters, you must
also put quotation marks (" ") around the
virtual disk name.
Parameter Description