Dell PowerVault MD3000i - Manual (Page 114)

114
Script Commands
"Show Virtual Disk Copy Target Candidates" on page 220
"Stop Virtual Disk Copy" on page 231
Commands Listed Alphabetically
Following are the script commands listed alphabetically.
Accept Storage Array Pending Topology
This command configures all or part of the pending host topology discovered
by the show storageArray pendingTopology command.
Syntax
accept storageArray pendingTopology (allHosts |
host " hostName " | hosts (" hostName1" ...
"hostNamen ")
Parameters
Activate Storage Array Firmware
This command activates firmware previously downloaded to the pending
configuration area in the RAID controller modules in the storage array.
Syntax
activate storageArray firmware
Parameters
None
Parameter Description
allHosts Selects all hosts identified by show storageArray pendingTopology.
host or hosts Name of the host to include in the storage array topology. You can
enter more than one host name. You must put quotation marks (" ")
around the host name.