Dell PowerVault MD3000i - Manual (Page 215)

Script Commands
215
Syntax
show storageArray iscsiNegotiationDefaults
Parameters
None.
NOTE:
Information returned includes RAID controller module default settings
(settings that are the starting point for negotiation), and the current active settings.
Example
-c "show storageArray iscsiNegotiationDefaults;"
Show Storage Array Pending Topology
This command identifies the hosts and host groups that the storage
management software discovered. Use the accept storageArray
pendingTopology command to create hosts and host groups from the
pending topology.
Syntax
show storageArray pendingTopology
Parameters
None.
Show Storage Array Unreadable Sectors
This command returns a table of the addresses of all unreadable sectors in the
storage array. The table is organized with column headings for the following
information:
1 Virtual disk user label
2 LUN
3 Accessible by host or host group
4 Date/Time
5 Virtual disk-relative logical block address
Hex format (0x nnnnnnnn)