Dell PowerVault MD3000i - Manual (Page 172)

172
Script Commands
NOTE:
When you use this command, you can specify one or more of the
parameters. You do not, however, need to use all of the parameters.
NOTE:
Setting availability to serviceMode causes the alternate RAID controller
module to take ownership of all virtual disks. The specified RAID controller module
no longer has any virtual disks and refuses to take ownership of any more virtual
disks. Service mode is persistent across reset and power cycles until the
availability
parameter is set to online.
NOTE:
Use the
show controller
NVSRAM command to display parts or all of the
NVSRAM.
Additional Information
The maxFramePayload option is shared between IPv4 and IPv6. The payload
portion of a standard Ethernet frame is set at 1500, and a jumbo Ethernet
frame is set at 9000. When using jumbo frames, all of the devices that are in
the network path should be capable of handling the larger frame size.
You must set the enableIPv4 parameter or the enableIPv6 parameter to
TRUE to make sure that the specific IPv4 setting or the specific IPv6 setting
is applied.
When the duplexMode parameter is set to TRUE, the selected Ethernet port
is set to full duplex. The default value is half duplex (the duplexMode
parameter is set to FALSE).
The portSpeed parameter is expressed as megabits per second (Mb/s).
The IPv6 address space is 128 bits. It is represented by eight 16-bit
hexadecimal blocks separated by colons. You may drop leading zeros, and you
may use a double colon to represent consecutive blocks of zeroes.
The default value for the IPv6HopLimit parameter is 64.
The default value for the IPv6NdReachableTime parameter is
30000 milliseconds.
rloginEnabled This parameter defines whether the remote login feature is
turned on or turned off. To turn on the remote login
feature, set this parameter to TRUE. To turn off the
remote login feature, set this parameter to FALSE.
Parameter Description