Dell PowerVault MD3000i - Manual (Page 174)

174
Script Commands
Parameters
NOTE:
When using this command, you can specify one or more of the parameters.
You do not, however, need to use all of the parameters. Using two many parameters
can cause host I/O errors or result in internal controller reboots because the time
period ends before the disk group definition is set.
NOTE:
The addPhysicalDisks or raidLevel operations cannot be stopped once they
have been initiated.
NOTE:
The time required to complete the addPhysicalDisks or raidLevel operations
is dependent on the number and size of the disks used.
Set Enclosure Attribute
This command sets user-defined attributes for an enclosure.
Syntax
set enclosure [ enclosureID ] (chassisName |
assetTag)= " userID "
Parameter Description
diskGroup Sequence number of the disk group for which to set properties.
You must put brackets ([ ]) around the disk group number.
addPhysicalDisks Identifies the physical disk by tray and slot location to include in
the disk group. Tray ID values are 0 to 99. Slot ID values are 0
to 31. You must put parentheses around the tray ID values and the
slot ID values.
raidLevel RAID level for the disk group. Valid values are 0, 1, 5, or 6.
owner RAID controller module that owns the disk group. Valid RAID
controller module identifiers are 0 or 1, where 0 is the RAID
controller module on the left and 1 is the RAID controller module
on the right when viewed from the rear of the enclosure. Use this
parameter only if you want to change the disk group owner.
availability Setting for the disk group, which is either online or offline.