Dell PowerVault MD3000i - Manual (Page 124)

124
Script Commands
Parameters
NOTE:
You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Create Host Port
This command creates a new HBA host port identification. The identification
is a software value that represents the physical HBA host port to the RAID
controller module. Without the host port identification, the RAID controller
module cannot receive instructions or data from the host port.
Syntax
create hostPort identifier=" wwid " userLabel=
" portLabel " host=" hostName "
Parameters
Parameter Description
userLabel Name to give the host group that you are
creating. You must put quotation marks
(" ") around the host group name.
Parameter Description
identifier WWID of the HBA host port. You must
put quotation marks (" ") around the
WWID.
userLabel Name to give the new HBA host port. You
must put quotation marks (" ") around
the port label.