Ieee 1394 device problems, Problems writing to an optical drive, Hard drive problems – Dell Vostro 2510 (Early 2009) User Manual
Page 9
Click the speaker icon in the lower-right corner of your screen.
Ensure that the volume is turned up by clicking the slidebar and dragging it up.
Ensure that the sound is not muted by clicking any boxes that are checked.
Check the speakers and subwoofer —
Problems writing to an optical drive
Close other programs —
The optical drive must receive a steady stream of data during the writing process. If the stream is interrupted, an error
occurs. Try closing all programs before you write to the optical.
Turn off standby mode in Windows before writing to a disc —
For information about setting power options, see the Dell™ Technology Guide on your computer or at support.dell.com. You
can also search for the keyword standby in Windows Help and Support for information on power management modes.
Hard drive problems
Run Check Disk —
Windows XP:
1. Click Start and click My Computer.
2. Right-click Local Disk C:.
3. Click Properties Tools Check Now.
4. Click Scan for and attempt recovery of bad sectors and click Start.
Windows Vista:
1. Click Start
and click Computer.
2. Right-click Local Disk C:.
3. Click Properties Tools Check Now.
The User Account Control window may appear. If you are an administrator on the computer, click Continue;
otherwise, contact your administrator to continue the desired action.
4. Follow the instructions on the screen.
IEEE 1394 Device Problems
CAUTION:
Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
NOTE:
Your computer supports only IEEE 1394a standard.
Ensure that the cable for the IEEE 1394 device is properly inserted into the device and into the connector on the
computer
Ensure that the IEEE 1394 device is enabled in system setup —
For more information on using the system setup
program, see the Dell™ Technology Guide on your computer or at support.dell.com.
Ensure that the IEEE 1394 device is recognized by Windows —