Display inverter, Replacing the display bezel, Removing the display inverter – Dell Vostro 2510 (Early 2009) User Manual
Page 42
9. Starting at the middle bottom of the display panel, use your fingers to separate the bezel from the top cover, then lift
the inside edges to separate the remainder of the bezel.
Replacing the Display Bezel
CAUTION:
Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
This procedure assumes that you have completed the removal procedure
1. Starting at any corner, use your fingers to gently snap the bezel into place to secure it to the top cover.
2. Replace the six M2.5 x 5-mm shoulder screws in the display bezel.
3. Replace the four rubber display bumpers and two mylar screw covers around the display bezel.
4. Replace the display assembly (see
Replacing the Display Assembly
5. Replace the keyboard (see
6. Replace the hinge cover (see
7. Replace the WLAN card (see
8. Replace the hard drive cover. See
for an illustration of the hard drive cover.
Display Inverter
Removing the Display Inverter
CAUTION:
Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
1. Follow the instructions in
Before Working on Your Computer
.
2. Remove the hard drive cover. See
for an illustration of the hard drive cover.
3. Remove the WLAN card (see
4. Remove the hinge cover (see
).
5. Remove the keyboard (see
6. Remove the display assembly (see
7. Remove the display bezel (see
8. Remove the M2 x 3-mm screw from the display inverter.
9. Disconnect the two display-inverter connectors.
10. Lift the display inverter out of the top cover.