Display cable, Removing the display cable – Dell Vostro 2510 (Early 2009) User Manual
Page 45
This procedure assumes that you have completed the removal procedure
1. Replace the eight M2 x 3-mm screws in the display panel.
2. Position the display panel assembly in the top cover.
3. Replace the camera/microphone assembly (see
Replacing the Camera and Microphone Assembly
).
4. Align the guide pins at the top of the display hinge panels and position the display panel in the top cover.
5. Replace the two M2 x 5-mm screws in the hinges.
6. Replace the display inverter (see
Replacing the Display Inverter
7. Replace the display bezel (see
8. Replace the display assembly (see
Replacing the Display Assembly
9. Replace the keyboard (see
10. Replace the hinge cover (see
11. Replace the WLAN card (see
12. Replace the hard drive cover. See
for an illustration of the hard drive cover.
Display Cable
Removing the Display Cable
CAUTION:
Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
1. Follow the instructions in
Before Working on Your Computer
.
2. Remove the hard drive cover. See
for an illustration of the hard drive cover.
3. Remove the WLAN card (see
4. Remove the hinge cover (see
).
5. Remove the keyboard (see
6. Remove the display assembly (see
7. Remove the display bezel (see
8. Remove the display inverter (see
9. Remove the camera/microphone assembly (see
Removing the Camera and Microphone Assembly
10. Remove the two M2 x 5-mm screws from the display bracket.
11. Lift the display panel out of the top cover.
12. Disconnect the display cable from the connector on the back of the display panel.