Dell Vostro 2510 (Early 2009) - Manual (Page 46)

1 display panel 2 display cable connector
3 display cable
Replacing the Display Cable
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
This procedure assumes that you have completed the removal procedure Removing the Display Cable .
1. Connect the display cable to the connector on the back of the display panel.
2. Align the guide pins at the top of the display hinge panels and position the display panel in the top cover.
3. Replace the two M2 x 5-mm screws on the display bracket.
4. Replace the display inverter (see Replacing the Display Inverter ).
5. Replace the display bezel (see Replacing the Display Bezel ).
6. Replace the display assembly (see Replacing the Display Assembly ).
7. Replace the keyboard (see Replacing the Keyboard ).
8. Replace the hinge cover (see Replacing the Hinge Cover ).
9. Replace the WLAN card (see Replacing a WLAN Card ).
10. Replace the hard drive cover. See Removing the Hard Drive for an illustration of the hard drive cover.
Camera and Microphone Assembly
Removing the Camera and Microphone Assembly
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at