Dell POWEREDGE 300 - Manual (Page 152)

152
Troubleshooting Your System
10 Remove processor 2. See "Replacing the Processor" on page 107.
To locate processor 2, see Figure 6-1.
If only one processor is installed, replace the processor. See "Getting Help"
on page 167.
11 Close the system. See "Opening and Closing the System" on page 70.
12 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
13 Run the appropriate online diagnostic test.
• If the tests complete successfully, go to.
• If the tests fail, the processor is faulty. See "Getting Help" on page 167.
14 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
15 Open the system. See "Opening and Closing the System" on page 70.
16 Swap processor 1 with processor 2. See "Replacing the Processor" on
page 107.
17 If you have tested each processor and the problem persists, the system
board is faulty. See "Getting Help" on page 167.
book.book Page 152 Sunday, June 21, 2009 5:16 PM