Dell POWEREDGE 300 - Manual (Page 134)

134
Troubleshooting Your System
• Drive-carrier connections to the SAS/SATA backplane, if applicable
3 Ensure that all cables are properly connected.
4 Close the system. See "Opening and Closing the System" on page 70.
5 Run the system board tests in the system diagnostics. See "Using Dell
PowerEdge Diagnostics" on page 153.
If the tests fail, see "Getting Help" on page 167.
Troubleshooting the System Battery
Problem
• System message indicates a problem with the battery.
• System Setup program loses system configuration information.
• System date and time do not remain current.
NOTE:
If the system is turned off for long periods of time (for weeks or months), the
NVRAM may lose its system configuration information. This situation is caused by a
defective battery.
Action
1 Re-enter the time and date through the System Setup program. See
"Entering the System Setup Program" on page 47.
2 Turn off the system and disconnect it from the electrical outlet for at least
one hour.
3 Reconnect the system to the electrical outlet and turn on the system.
4 Enter the System Setup program. See "Entering the System Setup
Program" on page 47.
If the date and time are not correct in the System Setup program, replace
the battery. See "System Battery" on page 112.
If the problem is not resolved by replacing the battery, see "Getting Help"
on page 167.
NOTE:
Some software may cause the system time to speed up or slow down. If the
system seems to operate normally except for the time kept in the System Setup
program, the problem may be caused by software rather than by a defective
battery.
book.book Page 134 Sunday, June 21, 2009 5:16 PM