Dell POWEREDGE 300 - Manual (Page 132)

132
Troubleshooting Your System
Remove and reinstall the drivers if applicable. See the NIC's
documentation.
• Change the autonegotiation setting, if possible.
• Use another connector on the switch or hub.
If you are using a NIC card instead of an integrated NIC, see the
documentation for the NIC card.
3 Ensure that the appropriate drivers are installed and the protocols are
bound. See the NIC's documentation.
4 Enter the System Setup program and confirm that the NICs are enabled.
See "Entering the System Setup Program" on page 47.
5 Ensure that the NICs, hubs, and switches on the network are all set to the
same data transmission speed. See the network equipment
documentation.
6 Ensure that all network cables are of the proper type and do not exceed the
maximum length.
If the problem persists, see "Getting Help" on page 167.
Troubleshooting a Wet System
Problem
• Liquid spilled on the system.
• Excessive humidity.
Action
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening and Closing the System" on page 70.
book.book Page 132 Sunday, June 21, 2009 5:16 PM