Dell OptiPlex GX1 User Manual
Page 62
Working Inside Your Computer: Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SIG/computer.htm[2/21/2013 12:07:23 PM]
4. Slide the expansion-card cage out of the chassis.
5. Lift the expansion-card cage up and away from the chassis.
Replacing the Expansion-Card Cage
Use the following procedure to replace the expansion-card cage:
1. With the securing lever in the upright position, align the slots in the left side of the expansion-card cage
with the tabs on the left side of the chassis (see
).
2. Rotate the securing lever downward until it is flush with the top of the chassis. Make sure that the riser
board is fully seated in the RISER connector on the system board.
3. Reconnect any cables you removed in step 2 of the previous procedure, "
4.
, and reconnect your computer and peripherals to their electrical outlets
and turn them on.
NOTE: If Enabled, the
option will cause the following message to be displayed
at the next system start-up:
ALERT! Cover was previously removed.
Rotating the Power Supply Away From the System Board
To access some components on the system board, you may have to rotate the system power supply out of
the way. Use the following procedure to rotate the power supply.
CAUTION: Before you remove the computer cover, see "
Safety First — For You and Your
."
1. Remove the computer cover as instructed in "
2. Disconnect the AC power cable from the AC power receptacle on the back of the power supply (see
Figure 8).
Figure 8. Rotating the Power Supply