Dell OptiPlex GX1 User Manual
Page 59
Working Inside Your Computer: Dell OptiPlex GX1 and GX1p Midsize Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SIG/computer.htm[2/21/2013 12:07:23 PM]
A jumper is referred to as open or unjumpered when the plug is pushed down over only one pin or if there is
no plug at all. When the plug is pushed down over two pins, the jumper is referred to as jumpered. In some
documents, the jumper setting may be shown in text as two numbers, such as 1-2. The number 1 is printed
on the circuit board so that you can identify each pin number based on the location of pin 1.
Figure 6 shows the location and default settings of the jumper blocks on your system board. See
the designations, default settings, and functions of your system's jumpers.
Figure 6. System Board Jumpers
Table 1. System-Board Jumper Settings
Jumper
Setting
Description
PSWD
Password features are enabled.
Password features are disabled.
BIOS
Reserved (do not change).
BUS66M
Reserved (do not change).
266MHZ*
Reserved (do not change).
300MHZ*
Reserved (do not change).
333MHZ*
Reserved (do not change).
350MHZ*
Reserved (do not change).
400MHZ*
Reserved (do not change).