Dell PowerVault 735N (Rackmount NAS Appliance) User Manual
Page 77
Jumpers, Switches, and Connectors: Dell Powervault 735N Systems Service Manual
file:///C:/Users/Phebega_Pericho/Desktop/spv735N/en/sm/jumpers.htm[3/15/2013 4:18:20 PM]
1. Turn off the system, including any attached peripherals, and disconnect the AC power cable from its
power source.
2.
Remove the optional front bezel
, if it has one.
4. Refer to "
" for the location of the password jumper (labeled PASSWD) on the
system board.
5. Remove the jumper plug from the PASSWD jumper.
6. Close the
and then reconnect the system to an electrical outlet and turn it on.
The existing passwords are not disabled (erased) until the system boots with the PASSWD jumper plug
removed. However, before you assign a new system and/or user password, you must install the jumper
plug.
NOTE: If you assign a new system and/or user password with the jumper plug still removed, the
system disables the new password(s) the next time it boots.
7. Repeat step 1.
8. Install the jumper plug on the PASSWD jumper.
9. Close the
and then reconnect the system and peripherals to their electrical outlets and
turn them on.
10. Assign a new system and/or user password.
To assign a new system password using the System Setup program, see "Assigning a System
Password" in the User's Guide. To assign a new user password using the System Setup program, see
"Assigning a Setup Password" in the User's Guide.