Dell PowerVault 735N (Rackmount NAS Appliance) User Manual
Page 35
Codes and Error Messages: Dell PowerVault 735N Systems Service Manual
file:///C:/Users/Phebega_Pericho/Desktop/spv735N/en/sm/beep.htm[3/15/2013 4:18:15 PM]
Hard disk
controller
failure
Incorrect configuration settings
in System Setup program,
improperly connected hard-
disk drive, faulty hard-disk
drive controller subsystem
(defective system board), or
loose power cable
Check the hard-disk drive configuration settings in
the
. Reinstall the hard-
disk drive. Check the interface cable and power
cable connections to the backplane board.
Invalid
configuration
information -
please run
SETUP program
Incorrect ISA_CLR jumper
configuration, incorrect
configuration settings in
System Setup program, or
faulty battery
Remove the plug from the ISA_CLR jumper. See
"
Jumpers, Switches, and Connectors
" for
instructions. Check the
configuration settings. Replace the battery. See
"
."
Invalid CPU
speed detected
Microprocessor not supported
by system
Install a correct version of the
the specified microprocessor connector.
Invalid NVRAM
configuration,
resource
reallocated
System detected and
corrected a resource conflict
when system resources were
allocated using the Resource
Configuration Utility
No action is required.
I/O parity
interrupt at
address
Expansion card improperly
installed or faulty
Reinstall the expansion cards (see "
"). If the problem persists, replace the
expansion card.
Keyboard
controller
failure
Defective keyboard/mouse
controller (defective system
board)
Keyboard failure
Keyboard cable connector
loose or improperly connected,
defective keyboard, or
defective keyboard/mouse
controller (defective system
board)
Check the keyboard cable connection. Replace
the keyboard. If the problem persists,
Keyboard data
line failure
Keyboard stuck
key failure
Keyboard cable connector
loose or improperly connected,
defective keyboard, or
defective keyboard/mouse
controller (defective system
board)
Check the keyboard cable connection. Replace
the keyboard. If the problem persists,
Memory address
line failure at
address, read
value expecting
value
Faulty or improperly seated
DIMMs or defective system
board
. If the problem
persists, replace the DIMMs. If the problem still
persists,
.