Dell POWEREDGE 1955 - Manual (Page 97)

Installing System Options
97
Figure 3-25. Removing and Installing the Server Module Control Panel Assembly
Installing the Server Module Control Panel
1 Place the new control panel under the server module top bracket and secure it with the two screws. See
Figure 3-25.
2 Route the control-panel cable under its retaining clip.
3 Connect the control-panel cable to the server module-board connector:
a Pull up the retaining clip on top of the connector.
b Slip the cable between the retaining clip and the connector and press down on the clip to secure
the cable.
NOTE:
The cable attaches to the connector on the control panel in the same manner.
4 Close the server module. See "Closing the Server Module" on page 76.
5 Install the server module. See "Installing a Server Module" on page 74.
1 screws (2) 2 control panel cable retaining
clip 3 retaining clip
4 server module-board
connector 5 control panel cable 6 top bracket
7 control panel
7
1
6
5
4
3
2