Dell POWEREDGE 1955 - Manual (Page 83)

Installing System Options
83
4 Align the connectors on the bottom of the daughter card with the connectors on the server module
board, and then press down on the card edges until it is fully seated.
5 Secure the daughter card to the server module board with the three screws.
6 Close the server module. See "Closing the Server Module" on page 76.
7 Install the server module. See "Installing a Server Module" on page 74.
Figure 3-17. Installing and Removing a Daughter Card
Removing a Daughter Card
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Remove the server module. See "Removing a Server Module" on page 73.
2 Open the server module. See "Opening the Server Module" on page 75.
1 daughter card 2 screw holes (3) 3 daughter card connectors on
server module board (2)
2
1
3