Dell Metered PDU LCD User Manual
Page 78
78
|
Web Interface Operation
Table 23 describes the attributes in the TCP/IP Control table.
Table 23. TCP/IP Control
Attribute
Description
BootP/DHCP Status
Enable or disable the Boot Protocol (BootP)/Dynamic Host Configuration Protocol
(DHCP) process. These protocols are used to obtain a dynamic IP address from a
BootP/DHCP server.
PING Echo
Enable or disable the Dell DPI to respond to Ping requests.
Network Upgrade
Enable or disable the Trivial File Transfer Protocol (TFTP) upgrade control. You can
use the provided upgrade utility on Windows using TFTP to upgrade the Dell DPI
firmware.
Telnet Connection
Enable or disable the terminal to the server application (Telnet) control process, such as
telnet 192.168.1.1. You can configure the Telnet protocol to use a port number other
than the standard Telnet port (23).
HTTP Support
Enable or disable the HTTP connection with the Dell DPI. You can configure the
HTTP protocol to use a port number other than standard HTTP port (80).
Adding and Rejecting IP Addresses for SNMP/HTTP Access Control
NOTE:
The default IP address setting is 255.255.255.255.
To set and accept IP addresses:
1
From the
Network
menu, click
Access Control
. The SNMP/HTTP Access Control page displays.
2
Enter configuration values in the
Access Control Table
3
Select
Accept
from the
Access Type
list.
4
Click
Set Value
.
5
This procedure is completed.
Rejecting IP Addresses for SNMP/HTTP Access Control
To reject IP addresses:
1
From the
Network
menu, click
Access Control
. The SNMP/HTTP Access Control page displays.
2
Enter the IP address in the
Access Control Table
3
Select
32
for the Mask value.
NOTE:
The Valid Address Range value is generated in the field automatically when the Mask value is set.
4
Select
Reject
from the
Access Type
list.
5
Click
Set Value
.
6
This procedure is completed.