Dell Metered PDU LCD - Manual (Page 77)

77 Web Interface Operation |
Table 22 describes the attributes in the General TCP/IPv6 Configuration table.
Table 22. General TCP/IPv6 Configuration
Attribute Description
Address Auto Configuration Enables or disables IPv6 address auto-configuration of the Dell DPI. If
auto-configuration is enabled, the DPI searches for a “Router Advertisement” message
to perform stateless auto-configuration. If no “Router Advertisement” message is found
on the same link or the same subnet, the DPI performs a stateful auto-configuration
using DHCPv6. Select Enabled or Disabled from the list.
NOTE: Always set this value to Disabled if you are configuring TCP/IPv4.
Address Status READ ONLY. Displays the status of Dell DPI IPv6 global address as valid or invalid.
Valid status means the IPv6 global address is ensured uniquely and can be used for
network communication. If IPv6 auto-configuration is enabled and successfully
auto-configures the IPv6 global address, the status reported in this field is Valid.
If the IPv6 auto-configuration fails, or if auto-configuration is disabled and manual
configuration fails, the status reported in this field is Invalid.
NOTE: The IPv6 link-local address is always valid on the same link or subnet.
Link-Local Address READ ONLY. The IPv6 link-local address of the Dell DPI.
Global Address IPv6 global address of the Dell DPI, such as 2001:B181:2::2E0:D8FF:FEFF:8A59.
Global Prefix Length Prefix length of Dell DPI IPv6 global address.
NOTE: If the prefix is 2001:B181:2::/64, the prefix length is 64. Normally, the prefix
length is limited to 0 to 64.
Default Router Address IPv6 address of Dell DPI default router.
Enabling TCP/IP Network Controls
To configure TCP/IP network controls:
1 From the Network menu, click Control . The Network Control page displays.
2 Enter configuration values in the TCP/IP Control table (see Table 23).
3 Click Save .
4 This procedure is completed.