Dell Latitude E6400 - Manual (Page 97)

Replacing a WPAN (UWB/BT) Card
1. Slide the card into the connector labeled WPAN/UWB/FCM.
2. Press the card down and hold it in place.
3. Replace the M2 x 3-mm screw.
4. Connect the blue antenna cable to the WPAN card.
5. Slide the left hinge cover back in place and replace the M2.5 x 5-mm screw on the hinge cover.
6. Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly ).
7. Follow the procedures in After Working on Your Computer .
Back to Contents Page
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and
realign the card.
NOTICE: To avoid damage to the WPAN card, ensure the cables are not under the card when you replace it.
NOTICE: Insert a WPAN card only into the slot labeled WPAN/UWB/FCM.