Replacing the palm rest assembly – Dell Latitude E6400 User Manual
Page 73
Replacing the Palm Rest Assembly
1.
Holding the palm rest at an angle, connect the front of the palm rest to the computer, securing all snaps.
2.
Lower and snap the left side into place.
3.
Connect the contactless smart card cable, the touchpad cable, the speaker cable, and the wireless switch cable to the system board.
4.
Replace the four M2.5 x 5-mm screws in the holes labeled "P".
5.
Turn the computer upside down, and replace the seven M2.5 x 5.5-mm screws on the bottom of the computer.
6.
Replace the right speaker grill (see
Replacing the Right Speaker Grill/Fingerprint Reader Assembly
).
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the LED cover (see
Replacing the LED Cover
).
9.
Replace the display assembly (see
Replacing the Display Assembly (E6400 and M2400)
or
Replacing the Display Assembly (E6400 ATG)
).
10.
Replace the modular drive (see
Replacing the Modular Drive
).
11.
Replace the hinge covers (see
Replacing the Hinge Covers
).
12.
Replace the heatsink assembly (see
Replacing the Processor Heatsink Assembly
).
13.
Replace the bottom of the base assembly (see
Replacing the Bottom of the Base Assembly
).
14.
Follow the procedures in
After Working on Your Computer
.
Back to Contents Page
1 2.5 x 5-mm screws (4)
2 speaker cable
3 wireless switch cable
4 touch pad cable
5 contactless smart card cable 6 palm rest
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.