Base assembly, Removing the bottom of the base assembly, Replacing the bottom of the base assembly – Dell Latitude E6400 User Manual
Page 4: Removing the base assembly
Back to Contents Page
Base Assembly
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Removing the Bottom of the Base Assembly
Replacing the Bottom of the Base Assembly
Removing the Bottom of the Base Assembly
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Close the display and turn the computer upside down.
3.
Loosen the captive screw.
4.
Slide the bottom of the base assembly away from the hinge covers, and lift to remove the bottom of the base assembly.
Replacing the Bottom of the Base Assembly
1.
Slide the bottom of the base assembly into place.
2.
Tighten the captive screw.
3.
Follow the procedures in
After Working on Your Computer
.
Removing the Base Assembly
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the bottom of the base assembly (see
Removing the Bottom of the Base Assembly
).
3.
Remove the card in the WWAN/FCM card slot, if present (see
Removing a WWAN Card
or
Removing an FCM from the WWAN/FCM Slot
).
4.
Remove the card from the WLAN/WiMax card slot, if present (see
Removing the WLAN/WiMax Card
).
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
1 hinges covers (2) 2 bottom of the base assembly
3 captive screw