Dell Latitude E6400 - Manual (Page 28)

4. Disconnect and unroute the display cable, touch screen cable, and the wireless cables (WLAN, WWAN, and WPAN). Position all cables to the rear of the
laptop after unrouting.
5. Remove the two M2.5 x 5-mm screws from the hinges.
6. Turn the computer topside up.
7. Open the display to 90 degrees and lift the display assembly off the base assembly.
Replacing the Display Assembly (E6400 ATG)
1. Position the cables on the display assembly away from the base assembly.
2. Align the display hinges with the holes in the base of the computer, and lower the display into place.
3. Close the display and turn the computer upside down.
4. Route the display cable, touch screen cable, and wireless (WLAN, WWAN, and WPAN) cables. Fit the cables under each tab in their respective routing
1 M2.5 x 5-mm screws (2) 2 touch screen cable
3 display cable 4 WPAN cable
5 WLAN cable 5 WWAN cable
1 display assembly 2 base assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.