Wpan (uwb/bt) card, Removing a wpan (uwb/bt) card – Dell Latitude E6400 User Manual
Page 96
Back to Contents Page
WPAN (UWB/BT) Card
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Replacing a WPAN (UWB/BT) Card
Removing a WPAN (UWB/BT) Card
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the bottom of the base assembly (see
Removing the Bottom of the Base Assembly
).
3.
Remove the M2.5 x 5-mm screw from the left hinge cover, then slide it forward and lift to remove it.
4.
Disconnect the blue antenna cable from the card.
5.
Remove the M2 x 3-mm screw. The card pops up at a 45-degree angle.
6.
Slide the card out of the card connector on the system board.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE:
WPAN is a generic name for Ultra Wide Band (UWB) and Bluetooth® (BT). Insert a WPAN card only into the slot labeled WPAN/UWB/FCM.
1
antenna cable
2
WPAN card
3
M2 x 3-mm screw
1
WPAN card
2
card connector