Hinge covers, Removing the hinge covers, Replacing the hinge covers – Dell Latitude E6400 User Manual
Page 62
Back to Contents Page
Hinge Covers
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Removing the Hinge Covers
The hinge covers are not interchangeable; the left one covers the DisplayPort connector and the right one covers the RJ-45 network connector.
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the bottom of the base assembly (see
Removing the Bottom of the Base Assembly
).
3.
Remove the M2.5 x 5-mm screw from each hinge cover.
4.
Slide each hinge cover forward and lift to remove it.
Replacing the Hinge Covers
1.
Slide the left hinge cover over the DisplayPort connector and slide the right hinge cover over the RJ-45 network connector.
2.
Replace the M2.5x5-mm screw in each hinge cover.
3.
Replace the bottom of the base assembly (see
Replacing the Bottom of the Base Assembly
).
4.
Follow the procedures in
After Working on Your Computer
.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
1 M2.5 x 5-mm screws (2) 2 hinge covers