Keyboard, Removing the keyboard, Replacing the keyboard – Dell Latitude E6400 User Manual
Page 63
Back to Contents Page
Keyboard
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Removing the Keyboard
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the LED cover (see
Removing the LED Cover
).
3.
Remove the two M2 x 3-mm screws along the top of the keyboard.
4.
Using the pull tab, gently lift the top of the keyboard, then pull back to disconnect the keyboard.
Replacing the Keyboard
1.
Holding the top of the keyboard slightly above the computer, slide the bottom of the keyboard in at an angle, and fit the tabs and keyboard connector
along the bottom of the keyboard beneath the front-inside edge of the palm rest.
2.
Carefully press each side to snap the keyboard into place.
3.
Replace the two M2 x 3-mm screws at the top of the keyboard.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE:
The key caps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Exercise care when removing and handling the
keyboard.
1 M2 x 3-mm screws (2) 2 keyboard
3 pull tab
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE:
The key caps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Exercise care when removing and handling the
keyboard.