Dell OptiPlex 170L - Manual (Page 59)

The computer should have changed the value of System Memory to reflect the newly installed memory. Verify the new total. If it is correct, skip to
step 10 .
9. If the memory total is incorrect, turn off and disconnect your computer and devices from their electrical outlets. Remove the computer cover and check
the installed memory modules to ensure that they are seated properly in their sockets. Then repeat steps 5 through 8.
10. When the System Memory total is correct, press to exit system setup.
11. Run the Dell Diagnostics to verify that the memory modules are operating properly.
Removing Memory
1. Follow the procedures in " Before You Begin ."
2. Press out the securing clip at each end of the memory module connector.
3. Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
Back to Contents Page
CAUTION: Before you begin this procedure, follow the safety instructions in the Product Information Guide.